Bitbox Dongle & Bitbox Module for MB Delphi Diesel CAN Work with Scanmatik 2 PRO SM2 Pro SM3 PRO Programmer

FIDs: 197, 214, 216, 217, 218, 254

Module for reading and writing through the diagnostic connector by CAN-bus for diesel Mercedes-Benz vehicles with Delphi CRD ECUs.

MB Delphi CRD3.xx TC1797 (FID: 214)

This FID is for working with Delphi CRD3.xx ECUs based on Infineon Tricore TC1797 with internal flash memory 4 Mb.

Allows reading and writing with checksumm correction by CANbus.

MB Delphi CRD3.xx TC1793 (FID: 197)

This FID is for working with Delphi CRD3.xx ECUs based on Infineon Tricore TC1793 with internal flash memory 4 Mb.

Allows reading and writing with checksumm correction by CANbus.

Attention! We strongly recommend to write this ECUs on the BENCH. Writing by OBD2 on vehicle can damage EEPROM in some cases.

MB Delphi CRD3.xx TC1793 BENCH (FID: 254)

FID for BENCH working for 2020 vehicles with Delphi CRD3.xx ECUs based on Infineon Tricore TC1793 with internal flash memory 4 Mb.

Allows reading and writing with checksumm correction by CANbus on the BENCH. Required DrewTech CarDAQ+, Scanmatik SM2 Pro or other J2534 device supported 800 kbit/s CAN.

Infiniti Delphi CRD3.xx (FID: 218)

This FID is for working with Delphi CRD3.xx ECUs based on Infineon Tricore TC1797 with internal flash memory 4 Mb.

Allows reading of calibration area and writing with checksumm correction by CANbus.

MB Delphi CRD2.xx (FID: 217)

This FID is for working with Delphi CRD2.xx ECUs based on MPC5566 with internal flash memory 3 Mb.

Allows reading and writing with checksumm correction by CANbus.

MB Delphi CRD.11 (FID: 216)

This FID is for working with Delphi CRD.11 ECUs based on MPC563 with external flash memory with total 2.5 Mb.

Allows reading and writing with checksumm correction by CANbus. If you have OBD writing issue - connect ECU on the bench.